No image

HV 120A ESC Custom

$149.00 (USD)
Double Quadro V3 – Cool Redundancy

8 ESCs on two boards (for Oktos) with heat sink! Extremely fast brushless controllers version V3 for our MikroKopter. Version with second databus for redundance operation IMPORTANT: Use FlightCtrl Firmware V2.02 (or higher), otherwise read the instructions in the wiki !
The board is tested and programmed (including bootloader) FlightCtrl, NaviCtrl, MKGPS and RC-Receiver are NOT included! Power voltage : 10 to 30V -> 3 -7S Lipo 6 -layer PCB for optimal heat dissipation . 70u copper layers make the entire circuit board to the heat sink . current: up to 60A (per BL-Unit) and 240A (all together) with appropriate cooling current limiting and temperature limiting Active freewheeling -> less power loss Fast response with speed control rapid acceleration and braking of the propeller. Active and seamless braking gives the speed precisely and quickly on the new setpoint . return energy to the lipo when braking. Seamless transition from acceleration to braking significantly faster control with speed control Redundance Operation with one ore two FlightControls possible all 8-BL-Controllers with additional second databus (UART) Two Lipo connection cables Connection of a secondary FlightControl via 3-line Molex cable Other Features Integrated Buzzer Integrated 12V voltage regulator for external LED-Supply Switchable LED output -> LEDs can flash in case of undervoltage Adjustable motor timing in several steps of 13-28° – compatible with the most common BL motors Adjustable switching frequency ( 10kHz – 20kHz ) PPM to 500 Hz with simultaneous I2C – bus operation for telemetry and data logging Integrated 12V stabilization for LED lighting and other 12V appliances Switchable outputs for lighting -> ZB The blinking lights at low voltage Software adjustable direction of rotation Adjustable current and temperature limits Adjustable start-PWM Silent Start: test tone at startup can be disabled Interface various interfaces for setpoint input ( I2C, PPM ( 500Hz ) , serial) Integrated current measurement measurement of the actual current and the used capacity on the Mikrokopter control voltage and temperature measurement with data transmission to the ground station and data logging 11-bit resolution (2048 steps ) various feedback to the MikroKopter-FlightCtrl ( blocked motor , power limiting , etc. ) extented configuration options (eg current limit , temperature limit , …) two LEDs (OK and Error ) Adressable by loder-jumpers (address 1-8) I2C bus access possible in  PPM mode – for data logging and telemetry in PPM mode status messages are transmitted to the FC ( engine blocks , Current, Self-test error …) current measurement up to 75A per controller Convenient configuration of the BL controller via FC Mechanical data hole: 3mm Dimensions (W x H ): see documention in the Wiki weight: ca. 260g Delivery 2 SMD preassembled, programmed and tested boards already mounted and soldered Lipo Power cable (open ends) 1-line cable for LED output control General Notice The electronic components must be protected from moisture and humidity. When operating under such special conditions a corresponding (removable) protective coating must be used. [...]
$1,415.00 (USD)